Installing the Print Cartridge

If the display shows [PRINTER ERROR] or [PRINTER ERROR/CHECK PAPER], open the cover and check for jammed paper. Remove any jammed paper (see page 62) and close the cover.

2 Remove only the tape from the new cartridge.

Make sure all

tape is removed.

CAUTION!

DO NOT touch

the gold contact area on the cartridge.

3Make sure the cartridge holder is in the position shown. Place your fingers on top of the holder and open the holder release.

CAUTION! DO NOT touch the gold contact area or pull on the cable.

If you are replacing the cartridge, remove the old cartridge. If you are going to use the old cartridge again, place it in an air-tight container (containers for this purpose can be purchased at most office supply stores).

4Insert the new print cartridge (). Close the holder (), making sure it clicks into place.

2

1

5Close the cover, pressing firmly on both front corners.

Display: [CHANGE CARTRIDGE]/ [1=NEW, 2=OLD].

6Press (NEW) if the cartridge you installed is new.

Display: [NEW CARTRIDGE?] / [OK:PRESS START]

Press (OLD) if the cartridge you installed is old.

7Press .

If you selected "OLD" in the previous step, this completes the installation procedure. (Note: If you find that print quality is not satisfactory, see p. 53 to align the print cartridge.)

10

Page 12
Image 12
Sharp UX-B800SE operation manual Installing the Print Cartridge, Remove only the tape from the new cartridge