USING THE SYSTEM CONFIGURATION PROGRAM
Parameter | Description |
MAX Number of Allowed | The maximum number of Telnet sessions |
Telnet Sessions | allowed to simultaneously access the agent |
| module. |
MAC Address | Physical address of the agent module. |
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the switch’s IP parameters. The screen shown below is described in the following table.
Network Configuration : IP Configuration | ||
======================================== | ||
| Interface Type : Ethernet | |
| IP Address | : 10.1.113.29 |
| Subnet Mask | : 255.255.0.0 |
| Gateway IP | : |
| IP State | : |
<APPLY> | <OK> | <CANCEL> |
Use <TAB> or arrow keys to move, other keys to make changes. | ||
|
|
|
Parameter | Description |
Interface Type | Indicates IP over Ethernet. |
IP Address | IP address of the stack you are managing. The system |
| supports SNMP over UDP/IP transport protocol. In this |
| environment, all systems on the Internet, such as |
| network interconnection devices and any PC accessing |
| the agent module (or running EliteView) must have an |
| IP address. |
| Valid IP addresses consist of four numbers, of 0 to 255, |
| and separated by periods. Anything outside of this |
| format will not be accepted by the configuration |
| program. |
Subnet Mask | Subnet mask of the switch you have selected. This mask |
| identifies the host address bits used for routing to |
| specific subnets. |
