Next, you must modify your PC’s network settings to enable it to communicate with the CyberGuard SG appliance.

Click Start ->Settings ->Control Panel and double click Network Connections (or in 95/98/Me, double click Network).

Right click on Local Area Connection and select Properties.

Note

If there is more than one existing network connection, select the one corresponding to the network interface card to which the CyberGuard SG appliance is directly attached.

Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP ->your network card name if there are multiple entries) and click Properties.

Figure 2-1

13

Getting Started

Page 17
Image 17
SnapGear 2.0.1 user manual Right click on Local Area Connection and select Properties