Operation Instruction
Connector Pin Outs: | Master Unit |
|
| Slave Unit | |
| RX | → To | → | TXD | |
| TX | → To | → | RXD | |
| GND | → To | → | GND | |
NOTE: Refer to the following for
Male Female
Pin 2 | RXD (Receive Data) |
Pin 3 | TXD (Transmit Data) |
Pin 5 | GND (Ground) |
Power Cord Connector
Connect the connector from the adaptor to the DVR, and connect the AC power cord to the adaptor and then to the wall outlet.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE CIRCUIT.
CAUTION: Ensure the DVR is not near any heat source that could cause overheating.
CAUTION: The DVR does not have an internal fan so leave a clearance of at least 6 inches near ventilation hole areas on each side panel of the unit for proper ventilation.
Your DVR is now ready to operate. Refer to Chapter 3 ─ Configuration and Chapter 4 ─ Operation.
6
