Texas Instruments TMS320C6454 Device Configuration at Device Reset, Configuration IPD PIN, AEA15

PRODUCT

TMS320C6454

Fixed-Point Digital Signal Processor

www.ti.com

SPRS311A –APRIL 2006 –REVISED DECEMBER 2006

3 Device Configuration

On the C6454 device, certain device configurations like boot mode, pin multiplexing, and endianess, are selected at device reset. The status of the peripherals (enabled/disabled) is determined after device reset. By default, the peripherals on the C6454 device are disabled and need to be enabled by software before being used.

3.1 Device Configuration at Device Reset

Table 3-1describes the C6454 device configuration pins. The logic level of the AEA[19:0], ABA[1:0], and PCI_EN pins is latched at reset to determine the device configuration. The logic level on the device configuration pins can be set by using external pullup/pulldown resistors or by using some control device (e.g., FPGA/CPLD) to intelligently drive these pins. When using a control device, care should be taken to ensure there is no contention on the lines when the device is out of reset. The device configuration pins are sampled during reset and are driven after the reset is removed. To avoid contention, the control device should only drive the EMIFA pins when RESETSTAT is low.

NOTE

If a configuration pin must be routed out from the device and 3-stated (not driven), the internal pullup/pulldown (IPU/IPD) resistor should not be relied upon; TI recommends the use of an external pullup/pulldown resistor. For more detailed information on pullup/pulldown resistors and situations where external pullup/pulldown resistors are required, see Section 3.7, Pullup/Pulldown Resistors.

Table 3-1. C6454 Device Configuration Pins (AEA[19:0], ABA[1:0], and PCI_EN)

PREVIEW

CONFIGURATION	NO.	IPD/
PIN		IPU (1)

[N25,

L26,

AEA[19:16]IPD L25,

P26]

AEA15 P27 IPD

FUNCTIONAL DESCRIPTION

Boot Mode Selections (BOOTMODE [3:0]).

These pins select the boot mode for the device.

0000 No boot (default mode)

0001 Host boot (HPI)

0010 Reserved

0011 Reserved

0100 EMIFA 8-bit ROM boot

0101 Master I2C boot

0110 Slave I2C boot

0111 Host boot (PCI)

1000 thru Reserved

1111

If selected for boot, the corresponding peripheral is automatically enabled after device reset. For more detailed information on boot modes, see Section 2.4, Boot Sequence. CFGGP[2:0] pins must be set to 000b during reset for proper operation of the PCI boot mode.

EMIFA input clock source select (AECLKIN_SEL).

0AECLKIN (default mode)

1SYSCLK4 (CPU/x) Clock Rate. The SYSCLK4 clock rate is software selectable via the Software PLL1 Controller. By default, SYSCLK4 is selected as CPU/8 clock rate.

(1)IPD = Internal pulldown, IPU = Internal pullup. For most systems, a 1-kΩresistor can be used to oppose the IPU/IPD. For more detailed information on pullup/pulldown resistors and situations where external pullup/pulldown resistors are required, see Section 3.7, Pullup/Pulldown Resistors.

50 Device Configuration Submit Documentation Feedback