Texas Instruments TMS320C6454 warranty System Reset, CPU Reset

PRODUCT PREVIEW

TMS320C6454

Fixed-Point Digital Signal Processor

www.ti.com

SPRS311A –APRIL 2006 –REVISED DECEMBER 2006

4.The device is now out of reset, device execution begins as dictated by the selected boot mode (see Section 2.4, Boot Sequence).

NOTE

The POR pin should be held inactive (high) throughout the Warm Reset sequence.

Otherwise, if POR is activated (brought low), the minimum POR pulse width must be met.

The RESET pin should not be tied together with the POR pin.

7.6.3System Reset

A System Reset is initiated by the emulator via the C64x+ emulation logic. This reset can be masked by the emulator.

The following memory contents are maintained during a System Reset:

∙DDR2 Memory Controller: The DDR2 Memory Controller registers are not reset. In addition, the DDR2 SDRAM memory content is retained if the user places the DDR2 SDRAM in self-refresh mode before invoking the System Reset.

∙EMIFA: The contents of the memory connected to the EMIFA are retained. The EMIFA registers are not reset.

Test, emulation, and clock logic are unaffected. The device configuration pins are also not re-latched and the state of the peripherals (see Table 3-4) is not affected.

During a System Reset, the following happens:

1.The System Reset is initiated by the emulator. During this time, the following happens:

–The reset signals flow to the entire chip resetting all the modules on chip except the test and emulation logic.

–The PLL controllers are not reset. Internal system clocks are unaffected. If PLL1/PLL2 were locked before the System Reset, they remain locked.

–The RESETSTAT pin goes low to indicate an internal reset is being generated.

2.After device initialization is complete, the RESETSTAT pin is deasserted (driven high). In addition, the PLL controllers pause their system clocks for about 10 cycles.

At this point:

–The state of the peripherals before the System Reset is not changed. For example, if McBSP0 was in the enabled state before System Reset, it will remain in the enabled state after System Reset.

–The I/O pins are controlled as dictated by the DEVSTAT register.

–The DDR2 Memory Controller and EMIFA registers retain their previous values. Only the DDR2 Memory Controller and EMIFA state machines are reset by the System Reset.

–The PLL controllers are operating in the mode prior to System Reset. System clocks are unaffected.

The boot sequence is started after the system clocks are restarted. Since the configuration pins (including the BOOTMODE[3:0] pins) are not latched with a System Reset, the previous values, as shown in the DEVSTAT register, are used to select the boot mode.

7.6.4CPU Reset

A CPU Reset is initiated by the HPI or PCI peripheral. This reset only affects the CPU. During a PCI-initiated CPU Reset, the PCI pins are set to their reset state. With the exception of the HRDY/PIRDY pin, the PCI pins have a reset state of high-impedance; the HRDY/PIRDY pin goes high during reset.

118 C64x+ Peripheral Information and Electrical Specifications Submit Documentation Feedback