Toshiba RAV-SM1104UT-E 1 2 3, 2 1 5, 3 1 4, External view of P.C. board assembly, Address setup

6. External view of P.C. board assembly

Terminator (SW01)

52

85

7. Address setup

In addition to set up the central control address, it is necessary to change the indoor unit number. (Line/Indoor/Group address).

For details, refer to TCC-LINK Adapter Installation Manual.

11-3. How to Set up Central Control Address Number

When connecting the indoor unit to the central control remote controller using TCC-LINK adapter, it is neces- sary to set up the central control address number.

• The central control address number is displayed as the line No. of the central control remote controller.

1.Setup from remote controller at indoor unit side

*If you use the network adapter P.C. board, it is effective only when No. 7 of setup switch SW01 on P.C. board is turned off.

<Procedure> Perform setup while the unit stops.

1

2

3

4

Push TEST + VENT buttons for 4 seconds or more.

When group control is executed, first the unit No. is displayed and all the indoor units in the group control are selected. In this time, fans of all the selected indoor units are turned on. (Fig. 1)

(Keep displayed status without pushing UNIT button.)

In case of individual remote controller which is not group-controlled, Line address and Indoor unit address are displayed.

Using temperature setup TEMP. buttons, specify item code 03.

Using timer time TIME buttons, select the setup data.

The setup data is shown in the table below (Table 1).

Push SET button. (OK if display goes on.) (Fig.1)

• To change the item to be set up, return to Procedure 2.

5 Push TEST	button.
The status returns to usual stop status.
	(Table 1)
Setup data	Central control address No.
0001	1
0002	2
0003	3
:	:
0064	64
0099	Unset (Setup at shipment from factory)

2

1

5

TEMP.			ON / OFF
	TIMER SET	FAN	MODE
	TIME	SAVE	VENT
FILTER	SET CL	SWING/FIX	UNIT LOUVER
RESET TEST

3

1

4

– 118 –