Toshiba RAV-SP1104ATZG-E General tools Conventional tools can be used, R410A Conventional air

4.Tools

1.Required Tools for R410A

Mixing of different types of oil may cause a trouble such as generation of sludge, clogging of capillary, etc. Accordingly, the tools to be used are classified into the following three types.

1)Tools exclusive for R410A (Those which cannot be used for conventional refrigerant (R22))

2)Tools exclusive for R410A, but can be also used for conventional refrigerant (R22)

3)Tools commonly used for R410A and for conventional refrigerant (R22)

The table below shows the tools exclusive for R410A and their interchangeability.

Tools exclusive for R410A (The following tools for R410A are required.)

Tools whose specifications are changed for R410A and their interchangeability

			R410A		Conventional air
			air conditioner installation		conditioner installation
No.	Used tool	Usage
			Existence of	Whether conven-	Whether conventional
			new equipment	tional equipment	equipment can be used
			for R410A	can be used
•	Flare tool	Pipe flaring	Yes	*(Note)	Yes
‚	Copper pipe gauge for	Flaring by conventional	Yes	*(Note)	*(Note)
	adjusting projection margin	flare tool
ƒ	Torque wrench	Connection of flare nut	Yes	No	No
„	Gauge manifold	Evacuating, refrigerant	Yes	No	No
…	Charge hose	charge, run check, etc.
†	Vacuum pump adapter	Vacuum evacuating	Yes	No	Yes
‡	Electronic balance for	Refrigerant charge	Yes	Yes	Yes
	refrigerant charging
ˆ	Refrigerant cylinder	Refrigerant charge	Yes	No	No
‰	Leakage detector	Gas leakage check	Yes	No	Yes
Š	Charging cylinder	Refrigerant charge	No	No	No

(Note) When flaring is carried out for R410A using the conventional flare tools, adjustment of projec- tion margin is necessary. For this adjustment, a copper pipe gauge, etc. are necessary.

General tools (Conventional tools can be used.)

In addition to the above exclusive tools, the following equipments which serve also for R22 are necessary as the general tools.

1)Vacuum pump

Use vacuum pump by

attaching vacuum pump adapter.

2)Torque wrench

3)Pipe cutter

4)Reamer

5)Pipe bender

6)Level vial

7)Screwdriver (+, –)

8)Spanner or Monkey wrench

9)Hole core drill

10)Hexagon wrench (Opposite side 4mm)

11)Tape measure

12)Metal saw

Also prepare the following equipments for other installation method and run check.

1)	Clamp meter	3)	IInsulation resistance tester (Megger)
2)	Thermometer	4)	Electroscope

– 8 –