Toshiba RAV-SM1104UT-E, RAV-SM1404UT-E, RAV-SM804UT-E 55, Item, Outline of specifications, Remarks

No.	Item		Outline of specifications	Remarks
15	Filter sign display	1)	The operation time of the indoor fan is calculated, the filter	[FILTER	] goes on.
	(Except wireless		reset signal is sent to the remote controller when the speci-
	type)		fied time (2500H) has passed, and it is displayed on LCD.
		2)	When the filter reset signal has been received from the
			remote controller, time of the calculation timer is cleared.
			In this case, the measurement time is reset if the specified
			time has passed, and display on LCD disappears.
16	Central control	1)	Setting at the centerl controller side enables to select the
	mode selection		contents which can be operated on the remote controller at
			indoor unit side.
		2)	Setup contents
			• 64 line central controller (TCB-SC642TLE2)	Display at remote
			[Individual]: Operated on the remote controller	controller side
			(Priority to second pushing)	(No display)
			[Central 1]: ON/OFF operation cannot be operated on	[Central	] goes on
			the remote controller.
			[Central 2]: ON/OFF, mode selection, temp. setup	[Central	] goes on
			operations cannot be operated on the remote
			controller.
			[Central 3]: Mode selection and temp. setup operations	[Central	] goes on
			cannot be operated on the remote controller.
			[Central 4]: Mode selection cannot be operated on the	[Central	] goes on
			remote controller.

*In case of the wireless type, the display lamp does not change but the contents are same. If operating an item which is prohibited by the central control mode from the remote controller, it is notified with the receive sound, Pi, Pi, Pi, Pi, Pi (5 times).

17	Energy-saving	1)	Selecting [AUTO] mode enables an energy-saving to be
	control		operated.
		2)	The setup temperature is shifted (corrected) in the range
			not to lose the comfort ability according to input values of
			various sensors.
		3)	Data (Input value room temp. Ta, Outside temp. To, Air
			volume, Indoor heat exchanger sensor temp. Tc) for
			20 minutes are taken the average to calculate correction
			value of the setup temperature.
		4)	The setup temperature is shifted every 20 minutes, and the
			shifted range is as follows.
			In cooling time: +1.5 to – 1.0K
			In heating time: –1.5 to +1.0K
18	Max. frequency	1)	This control is operated by selecting [AUTO] operation mode.
	cut control	2)	COOL operation mode: It is		3) HEAT operation mode: It is controlled
			controlled according to the following		according to the following figure if
			figure if To < 28°C.		To > 15°C.
							Max. frequency is
			Ta(˚C)		Ta(˚C)		restricted to approximately
				Normal control			the rated heating frequency
			+4		Tsh
			+3		–3
			Tsc		–4
						Normal control
				Max. frequency is
				restricted to approximately
				the rated cooling frequency

– 55 –