Wacom DTK-2200 user manual controls and input tools, troubleshooting

ContentsIndex

76

The pen selects everything or will not stop drawing.

Open the Wacom Tablet control panel and go to the PEN tab. Move the TIP FEEL slider toward FIRM, or select CUSTOMIZE... and increase the CLICK THRESHOLD setting. If this does not help, see testing controls and input tools.

Double-clicking is difficult.	Be sure you are quickly tapping the display screen twice in the same
	place. Wacom recommends using the side switch to double-click.
	Open the Wacom Tablet control panel and go to the PEN tab.
	Try increasing the TIP DOUBLE CLICK DISTANCE or using a lighter TIP FEEL.
	Set an ExpressKey to DOUBLE CLICK and use it to issue double-clicks.
	Windows: Try setting your system to launch programs with a single
	click. See clicking.
The eraser selects everything	Open the Wacom Tablet control panel and go to the ERASER tab.
or will not stop erasing.	Move the ERASER FEEL slider toward FIRM, or select CUSTOMIZE... and
	increase the CLICK THRESHOLD setting. If this does not help, see testing
	controls and input tools.

You notice a delay at the beginning of pen or inking strokes.

Open the Wacom Tablet control panel and go to the PEN tab.

Try decreasing the TIP DOUBLE CLICK DISTANCE. If that does not work, move the TIP DOUBLE CLICK DISTANCE slider to the OFF position in order to turn off double-click assist.

You have to press hard with	Open the Wacom Tablet control panel and go to the PEN tab.
the pen when clicking,	Move the TIP FEEL slider toward SOFT, or select CUSTOMIZE... and
drawing, or writing.	decrease the SENSITIVITY and CLICK THRESHOLD settings.
The pen tip does not function.	Be sure you are using only the pen that came with your product,
	or a Wacom accessory pen specified for use with the Cintiq 22HD.
	Other pens may not function properly on the pen display.
	Check the control panel PEN tab and verify that a CLICK function is
	assigned to the pen tip.
	Make sure the status LED lights blue when the tip is pressed. If the
	LED does not light, verify that the USB cable is plugged into an active
	port on your computer or on a USB hub.
	If the LED still does not light, you may have defective hardware (see
	troubleshooting).
The pen tip and screen cursor	Open the Wacom Tablet control panel and select the CALIBRATE tab.
do not properly line up.	Continue with calibrating the pen display.
Changing the function settings	Make sure you change the settings for the tool and application that you
for an input tool has no effect.	are using. See application-specific settings and working with multiple
	tools.

ContentsIndex

76