Wacom DTK-2200 user manual Using An Alternate Mount Or Stand

ContentsIndex

91

USING AN ALTERNATE MOUNT OR STAND

If using Cintiq in an installation that requires the use of an alternate mounting platform, you can mount the pen display onto any stand or mounting platform conforming to the VESA MIS-D 100/100 (4 screw) standard.

Notes:

Required mounting screws are 4 mm wide with a 0.7 mm pitch (M4 Regular). The pen display screw holes depth is 12 mm. Exceeding the clearance depth will damage the internal components of the pen display.

Any platform or fixture on which Cintiq is mounted must be able to support the weight of the interactive pen display.

To attach the pen display to a VESA mount:

1.Turn off your computer and power off Cintiq. Then disconnect all cables from between the pen display and your computer.

2.Remove Cintiq from the display stand. Place the pen display face down on a flat, soft surface (such as a cloth spread across a desktop).

3.Remove the bearing hub by unscrewing the four bearing hub attachment screws. Carefully separate the bearing halves and remove the bearing stopper to free up the cabling. Take care not to lose the small bearing stopper found within the inner groove of one of the hub sections.

Rear cover

Cable channel

Bearing stopper

Bearing hub sections (removed) and attachment screws

•Remove screws from rear cover and lift cover away from the pen display.

•Thread cables through the cable channel and reattach the rear cover, making sure to use the correct screws. The rear cover screws are shorter than the bearing hub screws.

ContentsIndex

91