106 Chapter 11Common Channel Functions
02R96—Owner’s Manual
When a Surround mode other than Stereo is selected, Aux Sends can be set to follow the
same Input Channel Surround Pan that applies to the Bus Outs, which is useful for feeding
Surround channel signals to external effects processors. This is turned on and off by using
the F.S buttons that appear below the Aux Send Pair buttons. When a pair of Aux Sends are
set to follow Surround Pan, their Aux Send Pair button is unavailable, and their Aux Pan
parameters (see page 84) are unavailable.
Grouping Output Channel Faders
The Bus Out, Aux Send, and Stereo Out faders can be grouped, allowing you to control the
level of several Output Channels simultaneously. There are four Output Channel Fader
groups: Q, R, S, and T.
1Use the DISPLAY ACCESS [GROUP] button to locate the Output Fader Group
page.
2Press the LAYER [MASTER] button.
3Use the Up/Down cursor buttons to select Fader groups QT.
The selected group is highlighted by a flashing cursor box.
4Use the [SEL] buttons to add and remove Output Channel faders to and from
the selected group.
When an Output Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
You can temporarily disable a Fader group in order to make adjustments to individual fad-
ers by touching two or more faders in the group, or by operating the fader while holding
down its [SEL] button.
Fader groups are active only in Fader mode. See “Selecting Fader Modes” on page 35 for
more information.