Yamaha 02R96 Setting Input Channel Levels, Grouping Input Channel Faders

Setting Input Channel Levels 65
02R96—Owner’s Manual
Setting Input Channel Levels
Input Channel levels can be set as follows.
1Use the LAYER buttons to select the Layers.
2Press the FADER MODE [FADER] button to select Fader mode.
3Use the faders to set the Input Channel levels.
Refer to the legend on the left side of the faders when setting Input Channel levels.
Fader positions can be viewed on the Fader View pages. See “Viewing Channel
Fader Settings” on page 109 for more information.
Grouping Input Channel Faders
Input Channel faders can be grouped, allowing you to control the level of several Input
Channels simultaneously. There are eight Input Channel Fader groups: A, B, C, D, E, F, G,
and H.
1Use the DISPLAY ACCESS [GROUP] button to locate the Input Channel Fader
Group pages.
The Fader Group parameters for the 56 Input Channels are divided between two pages. The
Input Channel 1–48 Fader Group page is shown below. The layout of the other page is the
same.
2Use the LAYER buttons to select the Layers.
The corresponding Fader Group page and group row is selected as each Layer is selected.
3Use the Up/Down cursor buttons to select Fader groups A–H.
The selected group is highlighted by a flashing cursor box.
4Use the [SEL] buttons to add and remove faders to and from the selected
group.
When an Input Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
You can temporarily disable a Fader group in order to make adjustments to individual fad-
ers by touching two or more faders in the group, or by operating the fader while holding
down its [SEL] button.
Fader groups are active only in Fader mode (i.e., when the FADER MODE [FADER] button
indicator is on). See “Selecting Fader Modes” on page 35 for more information.
25
49
1
50
40
30
20
15
10
10
5
0
5