160 Chapter 16Automix
02R96—Owner’s Manual
COPY button: This button is used to copy the specified Automix data. Use the channel
buttons to select the source channels. Use the IN and OUT parameters to specify the region
to be copied. Use the TO parameter to specify the point to which the specified data is to be
copied. Use the DESTINATION parameter to specify the channels to which the specified
data is to be copied. Use the PARAMETERS window to specify which Automix events are
to be copied. Then select the COPY button and press [ENTER]. Duplicate events at the
specified destination will be erased.
MOVE/MERGE button: This button is used to move/merge the specified Automix data.
To move events, set the SOURCE to CURRENT. Use the channel buttons to select the
source channels. Use the IN and OUT parameters to specify the region to be moved. Use
the TO parameter to specify the point to which the specified data it to be moved. Use the
DESTINATION parameter to specify the channels to which the specified data is to be
moved. Use the PARAMETERS window to specify which Automix events are to be moved.
Then select the MOVE button and press [ENTER].
To merge events from another Automix, select the SOURCE MEM option and specify the
source Automix. Use the channel buttons to select the source channels. Use the IN and OUT
parameters to specify the region to be merged. Use the TO parameter to specify the point to
which the specified data it to be merged. Use the DESTINATION parameter to specify the
channels to which the specified data is to be merged. Use the PARAMETERS window to
specify which Automix events are to be merged. Then select the MERGE button and press
[ENTER].
TRIM button: This button is used to trim the specified Automix data. Use the channel
buttons to select the source channels. Use the IN and OUT parameters to specify the region
to be trimmed. Use the TRIM EDIT IN and OUT parameters to specify the TRIM IN and
OUT times, and set the trim amount. Use the PARAMETERS window to specify which
Automix events are to be trimmed (see below). Then select the TRIM button and press
[ENTER].
For trimming, you can select the following Fader events on the PARAMETERS window:
FADER (i.e., Inputs Channels, Bus Out masters, Aux Send masters, and the Stereo Out),
AUX 1–8 (i.e., Aux Send levels 1–8).
UNDO button: This button works the same as the UNDO button on the Automix Main
page. See “UNDO” on page 148 for more information.