Yamaha 02R96 Using Talkback

Using Talkback 121
02R96—Owner’s Manual
Using Talkback
The Talkback function distributes the Talkback mic signal to the Studio Monitor Outs and
any Slot or Omni Outputs specified on the Talkback Setup page.
The TALKBACK LEVEL control sets the level of the built-in talkback micro-
phone.
The [TALKBACK] button has two modes of operation: If it’s pressed once (i.e.,
for less than 300 ms), the Talkback function is turned on and remains on when
the button is released. This is Latched mode (this mode can be disabled on the
Talkback Setup page). If it’s pressed and held for longer, the Talkback function is
turned on, but turns off when the button is released. This is Unlatched mode.
The [TALKBACK] button indicator flashes while the Talkback function is active.
Talkback Setup
1Use the MONITOR [DISPLAY] button to locate the Talkback Setup page.
2Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
OUTPUT ASSIGN: These buttons are used to assign the Talkback mic signal to Slot and
Omni Outputs.
TALKBACK DIMMER LEVEL: When the Talkback function is active, this determines the
amount of attenuation applied to sound sources assigned to the Studio Monitors and
selected for Talkback.
USE AD IN x AS TALKBACK: This allows you to select an AD Input as the Talkback sig-
nal source. Use the check box to turn this option on and off, and use the number parameter
to specify the number of the AD Input. The signal from the specified AD Input is mixed
with the Talkback mic signal. Turn down the TALKBACK LEVEL if you do not want to use
the Talkback mic.
NEVER LATCH TALKBACK: This options allows you to disable latching for the Talkback
function.
010
TALKBACKLEVEL
TALKBACK