Yamaha 02R96 186 , Scrub & Shuttle

186 Chapter 18—Pro Tools Remote Layer
02R96—Owner’s Manual
Scrub & Shuttle
The Parameter wheel can be used to scrub and shuttle as follows.
1Make sure that Pro Tools is stopped.
2Press the [SCRUB] button if you want to scrub, press the [SHUTTLE] button
if you want to shuttle.
The corresponding button indicator lights up. The [REW] and [FF] button indicators also
light up, and the cursor mode is set to Navigation (the CURSOR MODE section of the dis-
play shows “NAVIGATION”).
3Turn the Parameter wheel clockwise to scrub/shuttle forwards. Turn it coun-
terclockwise to scrub/shuttle backwards.
Scrub/shuttle starts at the in point of the selected region. If no region is selected, the edit
cursor position is used. Note that if the Edit Insertion Follows Scrub/Shuttle preference is
turned on in Pro Tools (Setups menu, Preferences command, Operation page), the cur-
rently selected region will be cancelled when the [SCRUB] or [SHUTTLE] button is
pressed.
Press the left cursor button to move to the in point. Press the right cursor button, to move
to the out point.
You can toggle between scrub and shuttle by pressing the [SCRUB] and [SHUTTLE] but-
tons, in which case scrub or shuttle continues from the current position.
4To stop scrub/shuttle, press the [SCRUB] or [SHUTTLE] button again, or press
the [STOP] button.
If you press the [REW], [FF], or [PLAY] button, scrub/shuttle operation is stopped before
rewind, fast forward, or playback commences.
While scrub/ shuttle is active, only the following Pro Tools/02R96 controls can be used:
[SCRUB] and [SHUTTLE] buttons, Parameter wheel, transport buttons, faders, [ON] but-
tons, and [SOLO] buttons. The current position can be stored as a marker by pressing the
[ENTER] button.
The scrub resolution depends on the current zoom setting, the more zoomed in you are, the
higher the resolution.