Remote control features

Simplified remote controlUse the supplied simplified remote control to make basic controls of this unit.

STANDBY

Sets the selected zone to the standby mode.☞ P. 26, 100

SYSTEM MEMORY

Save or recall the system settings.

☞ P. 86

PRESET +/–Recall the preset FM/AM stations, XM channels or SIRIUS channels.☞P. 49, 54, 59s(stop) / p(play) / b(skip backward) / a(skip forward)Control playback of the iPod.

☞ P. 63

STANDBYPOWER

SYSTEM MEMORY

1

2

3

4

INPUT

INT SOURCE

PRESETVOLUME

MUTE

POWER

Turn on the power.

☞ P. 26, 100

INPUTl / hSelect the input source.

☞ P. 35

VOLUME +/–Adjust the volume level.

☞ P. 35

MUTEMutes the audio output.

☞ P. 37

Remove the insulation sheet before using the remote control.

■Setting the controlling zone of thesimplified remote control

Use this feature to set the controlling zone (page 100) and remote control ID (page 102) of the simplified remote control.

Setting the remote control ID•ID1: Press and hold b and 1 for 3 seconds.•ID2: Press and hold b and 2 for 3 seconds.Setting the controlling zone•Main zone: Press and hold a and 1 for 3 seconds.•Zone 2: Press and hold a and 2 for 3 seconds.•Zone 3: Press and hold a and 3 for 3 seconds.■Replacing the battery in the simplifiedremote control

Change the battery when the operation range of the simplified remote control decreases.

Use a straight

Replace the

Close the

pin to remove

battery with a

cover.

the cover.

new CR2025

 

 

battery.

 

Notes

•Insert the battery according to the polarity markings (+ and –).

•If the batteries run out, immediately remove them from the simplified remote control to prevent an explosion or acid leak.

•If a battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.

•Before inserting new batteries, wipe the compartment clean.

•Dispose of batteries according to your regional regulations.

98 En