Customizing this unit (MANUAL SETUP)

Input/output assignmentI/O ASSIGNMENT

Use this feature to assign the input/output jacks according to the component to be used if the initial settings of this unit do not correspond to your needs. Change the parameter to reassign the respective jacks and effectively connect more components.

Once the input/output jacks are reassigned, you can select the corresponding component by using the CINPUT selector (or the input selector buttons (3)).

y

•“NONE” appears in the OSD when no input source is assigned to the jack.

•You cannot select a specific item more than once for the same type of jack.

•An asterisk (*) appears to the right of the jack names that have been changed from their previous settings.

•The input source currently assigned to the selected jack is shown in the parentheses next to “Current”.

Input rename INPUT RENAME

Use this feature to change the name of the input source (up to 9 characters) that appears in the OSD and in the front panel display.

•To locate the position to edit , press 8l / h.•To select a character, press 8k / n.•To confirm the setting, press 8ENTER.•To return to the previous screen without change, press9RETURN.

y

Press 8n to change the character in the following order, or press 8k to go in the reverse order: A to Z, 0 to 9, a to z, symbols (#, *, –, +, etc.), space.

Volume trim VOL. TRIM

Use this feature to adjust the level of the signal input at each jack. This feature is useful if you want to balance the level of each input source to avoid sudden changes in volume when switching between input sources.

Control range: –6.0 dB to +6.0 dB

Control step: 0.5 dB

Initial setting: 0.0 dB

y

This parameter also affects the signals output at the audio ZONE OUT jacks.

Decoder mode DECODER MODEUse this feature to switch the decoder activation mode.

Choice

Functions

 

 

AUTO

Automatically detects digital audio signal input

 

types and selects the appropriate decoder.

 

 

DTS

Activates the DTS decoder and plays back only

 

DTS digital audio signals when digital audio

 

signals are input.

 

 

Note

“DECODER MODE” is available only when the digital audio input jacks (HDMI, OPTICAL and/or COAXIAL) are assigned to the selected input source.

Audio input BGV BGV

Use this feature to select the video source played in the background of the selected audio input source.

Choice

Functions

 

 

BD/HD DVD,

Selects the corresponding input source as the

DVD, CBL/

background video source.

SAT, DVR,

 

VCR, V-AUX,

 

DOCK

 

 

 

OFF

Does not play the video source in the

 

background.

 

 

Charge on standby STANDBY CHARGE

Use this feature to select whether this unit charges the battery of the stationed iPod or not when this unit is in the standby mode.

Choice

Functions

 

 

AUTO

Charges the battery of the stationed iPod when

 

this unit is turned on and in the standby mode.

 

 

OFF

Charges the battery of the stationed iPod only

 

when this unit is turned on.

 

 

Start pairing START PAIRING

Use this feature to start pairing the connected Yamaha Bluetooth wireless audio receiver (such as YBA-10, sold separately) with your Bluetooth component. For details about the pairing, refer to “Pairing the Bluetooth™ receiver and your Bluetooth component” (page 65).

To ensure security, a time limit of 8 minutes is set for the pairing operation. You are recommended to read and fully understand all the instructions before starting.

1Press 8ENTER to start pairing.

The connected Bluetooth receiver starts searching Bluetooth components. “Searching...” appears in the OSD.

2Check that the Bluetooth component detects the Bluetooth receiver.For details, refer to the instruction manual of the Bluetooth component.

82 En