ignore the error and carry on the measurement. However, we recommend that you solve the problem before starting the measurement.

•If “E-10:INTERNAL ERROR” appears, you can select only “EXIT”.

•For details about each error message, see “AUTO SETUP” (page 113).

■If “WARNING” appears

When this unit detects potential problems during the automatic setup procedure, “WARNING” appears in the result screen. Check the warning messages to correct your speaker settings.

y

The adjustments are made even if “WARNING” appears, however they may not be optimal.

1Make sure the pointer is pointing at “WARNING” and then press 8ENTER todisplay the detailed information about the warning.The number on the right of “WARNING” indicates the number of warning messages.

AUTO SETUP

. WARNING (2)

RESULT

 

MLT :

1

SP :

5/4/0.1

DIST:

14.0/17.0ft

LVL : -10.0/+5.0dB

>SET

CANCEL

[]/[p]: Up/Down

[ENTER]: Detail

2Press 8l / h repeatedly to toggle between the warning displays.

WARNING

W-1:OUT OF PHASE

Reverse channel

FL ---

CENTER

---PR

SL ---

SBL ---

[p]/[[]: Select

[ENTER]: Return

y

•For details about each warning message, see “AUTO SETUP” (page 113).

•When the corresponding warning message is not applicable to a speaker, “– – –” is displayed instead.

•If “SWFR:TOO LOW” or “SWFR:TOO HIGH” appears under “W-3:LEVEL ERROR”, adjust the volume level of the subwoofer.

3Press 8ENTER to return to the top resultdisplay.

Optimizing the speaker setting for your listening room

Advanced automatic setup

If you have done all the preparations necessary, follow the procedure below to optimize the setup of this unit for multiple listening positions.

1Place the optimizer microphone at the first listening position.

The following illustration shows how to place the optimizer microphone in order to optimize the setup of this unit for seven listening positions for example.

17

26 3 4 5

1/2/3/4/5/6/7: Listening positions

2Press 8k / n repeatedly to select “MULTI MEASURE” and then press 8l / h repeatedly to set the number of the listening position you want to make the measurement at.

Choices: 1 (default), 2, 3, 4, 5, 6, 7, 8

AUTO SETUP

SETUP;;;;;;;;;AUTO

. MULTI MEASURE;;;;7

START

[]/[p]: Up/Down

[p]/[[]: Select

3Press 8k / n repeatedly to select “START” and then press 8ENTER.

AUTO SETUP

SETUP;;;;;;;;;AUTO MULTI MEASURE;;;;7

. START

[]/[p]: Up/Down

[ENTER]: Start

PREPARATION

English

33 En