Yamaha RX-V1900BL 80 En, 4 VIDEO MENU, E)AUDIO SET, Pure direct, COMPONENT I/P, HDMI audio HDMI AUDIO, Tone bypass TONE BYPASS, ■Pure direct F)PURE DIRECT

Customizing this unit (MANUAL SETUP)

■Audio settings E)AUDIO SETTone bypass TONE BYPASS

Use this feature to select whether the audio output bypasses the tone control circuitry when “TREBLE” and “BASS” are set to 0 dB (page 46).

Choice	Functions
AUTO	Automatically bypasses the tone control
	circuitry to provide the purest signal possible
	when “TREBLE” and “BASS” are set to 0 dB.
OFF	Does not bypass the tone control circuitry.

HDMI audio HDMI AUDIO

Use this feature to select the types of the audio signals output at the HDMI OUT jack on the rear panel of this unit.

Choice	Functions
AMP	Outputs audio signals that can be decoded by
	this unit.
AMP+TV	Outputs audio signals that can be decoded by
	your video monitor connected to the HDMI
	OUT jack of this unit.

Note

Available audio/video signals depend on the specification of the connected video monitor. Refer to the instruction manuals of your video monitor and audio source component.

■Pure direct F)PURE DIRECT

Use this feature to select whether this unit outputs the video signals when this unit is in the Pure Direct mode.

ChoiceFunctions

AUDIO Does not Output video signals.

AUDIO+VID Outputs video signals. For the better sound

EOquality, this unit only activates the limited video features.

Note

You cannot use the OSD menu even if “PURE DIRECT” is set to “AUDIO+VIDEO”.

4 VIDEO MENUUse this feature to adjust the video parameters.

y

You can reset the all parameters in “VIDEO MENU” to the initial factory settings by using “VIDEO” of “INITIALIZE” in “ADVANCED SETUP” (page 103).

Video conversion VIDEO CONV.

Use this feature to set whether to convert the video signals input at the VIDEO, S VIDEO, and COMPONENT VIDEO jacks.

Choice	Functions
ON	Converts composite, S-video, and component
	video signals interchangeably and up-converts
	composite, S-video, and component video
	signals to HDMI video signals.
OFF	Does not convert any signals.

Notes

•This unit does not convert 480 line video signals and 576 line video signals interchangeably.

•480p-, 576p-, 1080i- and 720p-resolution video signals cannot be output at the S VIDEO and VIDEO MONITOR OUT jacks.

•The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component.

•When composite video or S-video signals from a VCR are converted into component video signals, the picture quality may suffer depending on your VCR.

•Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set “VIDEO CONV.” to “OFF”.

Component interlace/progressive up-conversionCOMPONENT I/P

Use this feature to activate or deactivate the analog interlace/progressive conversion of the analog video signals input at the composite video, S-video and component video jacks so that the analog video signals deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p are output at the COMPONENT MONITOR OUT jacks.

Choice	Functions
ON	Activates the analog interlace/progressive up-
	conversion of the analog video signals.
OFF	Deactivates the analog interlace/progressive up-
	conversion of the analog video signals.

80 En