Yamaha RX-V1900BL 100 En, Controlling Zone 2 or Zone, ZONE, ZONE, ZONE2, ZONE3, Press, Press, ZONE CONTROLS, ZONE CONTROLS, ■Basic operation, Front panel operations

Using multi-zone configuration

■Using the internal amplifiers of this unitImportant safety notice

The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.

If you want to use one internal amplifier (SP1 or SP2) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and set “AMP” to “[SP1]” or “[SP2]” (page 85).

If you want to use two internal amplifiers (SP1 and SP2) of this unit

Connect the Zone 2 and Zone 3 speakers directly to the SP1 and SP2 speaker terminals and set “AMP” to “BOTH” (page 85).

						SP2
R	SP1			L	ZONE 2/ZONE 3
	PRESENCE/ZONE 2/ZONE 3				R	L
+	–	–		+
					+
R	SURROUND BACK/			L
	BI-AMP		SINGLE		–
+	–	–		+

Second zone	Third zone
(Zone 2)	(Zone 3)

This unit

Controlling Zone 2 or Zone 3

You can select the zone you want to control by using the control buttons on the front panel or on the remote control.

■Basic operationFront panel operations

ZONE2Controls the Zone 2 amplifier or tuner functions.ZONE3Controls the Zone 3 amplifier or tuner functions.

y

You must complete this step within 10 seconds while the selected zone flashes in the front panel display. Otherwise, the currently selected zone mode is automatically canceled.

1Press PZONE 2 or PZONE 3 on the front panel to individually turn on or off Zone 2 or Zone 3.

2Press PZONE CONTROLS on the front panel repeatedly to select the zone you want to control.

Each time you press PZONE CONTROLS, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 10 seconds. However, no indicator flashes when the main zone is selected.

ZONE2 ZONE3

No indicator flashes

when the main zone is selected.

3Perform the desired operation in the selected zone (page 101).

y

To turn off the desired zone, press PZONE 2 or PZONE 3 again.

Remote control operations1Press GZONE repeatedly to select the zone you want to control.

“MAIN”, “ZONE 2”, or “ZONE 3” indicator appears in the display window (4) on the remote control.

(Zone 2) (Zone 3) (Main zone)

100 En