Troubleshooting
■Remote controlProblem | Cause | Remedy | See | |
page | ||||
|
|
| ||
The remote control | Wrong distance or angle. | The remote control will function within a maximum | ||
does not work or |
| range of 6 m (20 ft) and no more than 30 degrees off- |
| |
function properly. |
| axis from the front panel. |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. | — | |
| inverter type of fluorescent lamp, etc.) is |
|
| |
| striking the remote control sensor of this |
|
| |
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | ||
|
|
|
| |
| The operation mode selector is set | Set the operation mode selector correctly. When | — | |
| incorrectly. | operating this unit, set it to the EAMP position. |
| |
|
| When operating the component selected by the input |
| |
|
| selector button, set it to the ESOURCE position. |
| |
|
| When operating the TV set in the 3TV area, set it to |
| |
|
| the ETV position. |
| |
|
|
|
| |
| The control zone setting is incorrect. | Select the zone you want to control. | ||
|
|
|
| |
| The remote control code is not correctly | Set the remote control code correctly using | ||
| set. | “List of remote control codes” at the end of this |
| |
|
| manual. |
| |
|
|
|
| |
|
| Try setting another code of the same manufacturer | ||
|
| using “List of remote control codes” at the end of this |
| |
|
| manual. |
| |
|
|
|
| |
| The remote control ID of the remote | Match the remote control ID of this unit and the | ||
| control and this unit do not match. | remote control. |
| |
|
|
|
| |
| Even if the remote control code is | Program the necessary functions independently into | ||
| correctly set, there are some models that | the programmable buttons using the Learn feature. |
| |
| do not respond to the remote control. |
|
| |
|
|
|
| |
The remote control | The batteries of this remote control and/or | Replace the batteries. | ||
does not learn new | the other remote control are too weak. |
|
| |
functions. |
|
|
| |
The distance between the two remote | Place the remote controls at the proper distance. | |||
| ||||
| controls is too much or too little. |
|
| |
|
|
|
| |
| The signal coding or modulation of the | Learning is not possible. | — | |
| other remote control is not compatible |
|
| |
| with this remote control. |
|
| |
|
|
|
| |
| Memory capacity is full. | Delete other unnecessary functions to make room for | ||
|
| the new functions. |
| |
|
|
|
|
INFORMATION | ADDITIONAL |
|
|
English