Connections

Setting the speaker impedance

Caution

If you are to use 6 ohm speakers, set “SPEAKER IMP.” to “6Ω MIN” as follows BEFORE using this unit. You can also use 4 ohm speakers as the front speakers (page 102).

1Make sure this unit is turned off.2Press and hold OSTRAIGHT on the front panel and then press AMASTER ON/OFFinward to the ON position.

This unit turns on, and the advanced setup menu appears in the front panel display.

 

While holding

STRAIGHT

down

EFFECT

MASTER

 

3Rotate the NPROGRAM selector to select “SPEAKER IMP.”.4Press OSTRAIGHT repeatedly to select “6Ω MIN”.

5Press AMASTER ON/OFF to release it outward to the OFF position to save the new setting and turn off this unit.

Note

The setting you made is reflected next time you turn on this unit.

Turning this unit on and off■Turning on this unitPress AMASTER ON/OFF on the front panel inward to the ON position.

When you turn on this unit by pressing AMASTER ON/ OFF, the main zone is turned on.

■Turning off this unit

Press AMASTER ON/OFF on the front panel again to release it outward to the OFF position.

■Set the main zone to the standby modePress BMAIN ZONE ON/OFF(or CSTANDBY).■Turning on the main zone from the standby modePress BMAIN ZONE ON/OFF (or DPOWER).

y

•Basically, we recommend that you use the standby mode to turn off this unit. In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.

•BMAIN ZONE ON/OFF, CSTANDBY and DPOWER are operational only when AMASTER ON/OFF is pressed inward to the ON position.

•When you turn on this unit, there will be a delay for a few seconds before this unit can reproduce sound.

If there are some problems...•First, turn off and then turn on this unit again.•If problems persist, initialize the parameters of this unit (page 115).

26 En