Yamaha RX-V1900BL Optimizing the speaker setting for your listening room, 30 En, Basic automatic setup, Before starting the automatic setup, ❏This unit is turned on

Optimizing the speaker setting for your listening room

This unit employs the YPAO (Yamaha Parametric room Acoustic Optimizer) technology which lets you avoid troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening environment. In addition, the multi-point measurement feature enables you to optimize the setup of this unit for up to eight listening positions.

Before starting the automatic setup

1Make sure of the following check points

“MIC ON View OSD MENU” appears in the front panel display and the “AUTO SETUP” screen appears on the video monitor.

AUTO SETUP

SETUP;;;;;;;;;AUTO MULTI MEASURE;;;;1

. START

before starting the automatic setup operations.❏Speakers are connected appropriately.❏Headphones are disconnected from this unit.❏This unit is turned on.

❏The connected subwoofer is turned on and the volume level is set to about half way (or slightly less).

❏The crossover frequency controls of the connected subwoofer is set to the maximum.

[]/[p]: Up/Down

[ENTER]: Start

y

You can also run “AUTO SETUP” using the system menu that appears in the OSD or in the front panel display. This manual uses the OSD illustrations to explain the automatic setup procedure.

3Start the automatic setup.

VOLUME		CROSSOVER
		HIGH CUT
MIN	MAX	MIN	MAX

Controls of a subwoofer (example)

To optimize the setup of this unit for one listening position, follow “Basic automatic setup” (page 30). To optimize the setup of this unit for multiple listening positions, follow “Advanced automatic setup” (page 33).

❏The room is sufficiently quiet.❏Set the operation mode selector on the remote control to EAMP.

Notes

•Be advised that it is normal for loud test tones to be output during the automatic setup procedure.

•To achieve the best results, make sure the room is as quiet as possible while the automatic setup procedure is in progress. If there is too much ambient noise, the results may not be satisfactory.

Basic automatic setup

If you have done all the preparations necessary, follow the procedure below to optimize the setup of this unit for one listening position.

1Place the optimizer microphone at your normal listening position on a flat level surface with the omni-directional microphone heading upward.

Optimizer microphone

2Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel.

AUDIO	TONE					SEARCH	STEREO/
SELECT	CONTROL	ENTER	PRESET/TUNING/CH		MEMORY	MODE	MONO	CATEGORY	INFO
								BAND
		STRAIGHT				ZONE ON/OFF		ZONE CONTROLS
				MULTI ZONE
		EFFECT				ZONE 2	ZONE 3
		YPAO	SILENT CINEMA	S VIDEO	VIDEO	L AUDIO R		OPTICAL
	PROGRAM	OPTIMIZER			VIDEO AUX
		MIC	PHONES

Omni-directional microphone

30 En