Optimizing the speaker setting for your listening room
6Press 8l / h repeatedly to toggle between the setup result displays.Press 8k/ nto toggle between the parameters in the result.Number of the measured points
Results of the speaker connection and wiring
Results of the speaker distance from the listening position
Results of the speaker detection and size
Results of the parametric equalizer of each speaker
Results of the speaker output level
y
•If you are not satisfied with the results or want to manually adjust each parameter, use “MANUAL SETUP”
•You can select the parametric equalizer type with “PEQ SELECT” (page 79).
Notes
•The distances displayed in the “DISTANCE” results may be longer than the actual distance depending on the characteristics of your subwoofer or external amplifiers if you connect them.
•In the “EQ” results, different values may be set for the same band to provide finer adjustments.
AUTO SETUP
| RESULT |
|
| MLT : | 1 |
| SP : | 5/4/0.1 |
| DIST: | 14.0/17.0ft |
. | LVL : | |
>SET | CANCEL | |
[]/[p]: Up/Down
[ENTER]: Enter
8Press 8l / h to select “SET” or “CANCEL” and then press 8ENTER.AUTO SETUP
| RESULT |
|
| MLT : | 1 |
| SP : | 5/4/0.1 |
| DIST: | 14.0/17.0ft |
. | LVL : | |
>SET | CANCEL | |
[]/[p]: Up/Down
[ENTER]: Enter
Choices: SET, CANCEL•Select “SET” to confirm the “AUTO SETUP” results.•Select “CANCEL” to cancel the “AUTO SETUP” results.9Disconnect the optimizer microphone or press HMENU to exit from "SET MENU".Note
If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to recalibrate your system.
■If an error screen appearsPress 8l / h to select “RETRY” or “EXIT” and then press 8ENTERThe following screen is an example whereERROR
. >RETRY EXIT
[p]/[[]: Select
[ENTER]: Enter
Choices: RETRY, EXIT•Select “RETRY” to retry the “AUTO SETUP” procedure.•Select “EXIT” to exit from the “AUTO SETUP” procedure.y
• If