Zebra Technologies 79695L-002 Clean the Cutter Module, To expose the, To clean the cutter module, complete these steps:

108Routine Maintenance Cleaning Procedures

Clean the Cutter Module

If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.

Caution • For personnel safety, always power off and unplug the printer before performing this procedure.

To clean the cutter module, complete these steps:1.Turn the printer off (O), and unplug the printer from its power source.

2.

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

Remove the cutter shield (1) by removing the cutter shield thumbscrew and lock washer (2).

1 2

3.To expose the V-shaped cutter blade, turn the cutter motor thumbscrew (1) counterclockwise to lower the blade.

1

79695L-002 Rev. A Z Series®/RZ™ Series User Guide 6/6/08