Zebra Technologies 79695L-002 See, Figure, 5.Replace the cutter shield, Figure 18 • Cleaning the Cutter Module

Routine Maintenance 109

Cleaning Procedures

4.See Figure 18. Using the swab from the Preventive Maintenance Kit (part number 47362), wipe along the upper cutting surface (1) and the cutter blade (2). In place of the Preventive Maintenance Kit, you may use a clean swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%). Allow the solvent to evaporate.

Figure 18 • Cleaning the Cutter Module

1

2

5.Replace the cutter shield.

6.Plug the printer into its power source, and then turn on (I) the printer. The lower cutter blade returns to its correct operating position.

7.If the cutter continues to perform unsatisfactorily, contact an authorized service technician.

6/6/08 Z Series®/RZ™ Series User Guide 79695L-002 Rev. A