82Configuration

Standard Control Panel Parameters

Table 12 • Printer Parameters (Page 14 of 26)

Language/Parameter Action/Explanation

Initialize Flash Memory

This option erases all previously stored information from Flash memory.

Caution • This option completely erases the Flash memory.

To initialize Flash memory:

1.Press SELECT to select the parameter.

2.If prompted for a password, enter the printer password. For instructions, see Change Password-Protected Parameters on page 66.

The display shows INITIALIZE FLASH?

3.Press PLUS (+) to select YES.

The display shows ARE YOU SURE?.

4.Do you want to continue?

•Press MINUS (-)to select NO to cancel the request and return to the

INITIALIZE FLASH prompt.

•Press PLUS (+) to select YES and begin initialization. When initialization is complete, the control panel displays

INITIALIZING MEMORY COMPLETED.

Note • Depending on the amount of free FLASH memory, initialization may take up to 1 minute to complete.

5.Press SELECT to accept any changes and deselect the parameter.

Print Sensor Profile

A sensor profile shows sensor settings compared to actual sensor readings. This label (which will extend across several actual labels or tags) can be used to troubleshoot printing problems. To interpret the results of the sensor profile, see Sensor Profile on page 139.

To print a sensor profile:

1.Press SELECT to select the parameter.

2.Press PLUS (+) to start this standard calibration procedure and print a media sensor profile.

3.If the sensitivity of the sensors must be adjusted, perform Calibrate Media and Ribbon Sensor Sensitivity on page 83.

4.Press SELECT to accept any changes and deselect the parameter.

79695L-002 Rev. A

Z Series®/RZ™ Series User Guide

6/6/08