Zebra Technologies 79695L-002 Additional Steps for Cutter or Delayed Cut Mode, on page, on page, After completing, Feed the media through the cutter (1)

50Operations Load Media

Additional Steps for Cutter or Delayed Cut Mode

After completing Beginning Steps for all Print Modes and Printer Options on page 41, continue with this section to operate the printer in Cutter or Delayed Cut mode.

To operate the printer in Cutter or Delayed Cut mode, complete these steps:

1.

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

Feed the media through the cutter (1).

1

2.Slide in the media guide until it touches the outer edge of the media.

3.Set the printer to Cutter or Delayed Cut mode. See Select Print Mode on page 72 for instructions.

79695L-002 Rev. A Z Series®/RZ™ Series User Guide 6/6/08