Configuration

 

73

 

 

 

 

 

 

 

 

 

Standard Control Panel Parameters

 

 

 

 

Table 12 • Printer Parameters (Page 5 of 26)

 

 

 

 

 

 

Language/Parameter

 

Action/Explanation

 

 

 

 

APL-D only

 

Set Module A Storage Device for APL-D

 

 

 

 

Default Value: NONE

 

 

 

 

 

 

Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2

 

 

 

To change the value shown:

 

 

 

1.

Press SELECT to select the parameter.

 

 

 

2.

Press PLUS (+) or MINUS (-)to scroll through the options.

 

 

 

 

 

3.

Press SELECT to accept any changes and deselect the parameter.

 

 

 

 

 

APL-D only

 

Set Module B Storage Device for APL-D

 

 

 

Default Value: NONE

 

 

 

 

 

 

Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2

 

 

 

To change the value shown:

 

 

 

1.

Press SELECT to select the parameter.

 

 

 

2.

Press PLUS (+) or MINUS (-)to scroll through the options.

 

 

 

 

 

3.

Press SELECT to accept any changes and deselect the parameter.

 

 

 

 

 

APL-I only

 

Set Printer Resolution for APL-I

 

 

 

Sets the dot size for backward compatibility with some older APL-I

 

 

 

 

 

 

printers.

 

 

 

Default Value: 5 MIL

 

 

 

Selections: 5 MIL, 10 MIL, 15 MIL

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to scroll through the options.

3.Press SELECT to accept any changes and deselect the parameter.

Set Media Type

This parameter tells the printer the type of media that you are using (see Types of Media on page 33 for more information). Selecting continuous media requires that you include a label length instruction in your label format (^LLxxxx if you are using ZPL or ZPL II).

When non-continuous media is selected, the printer feeds media to calculate label length (the distance between two recognized registration points of the inter-label gap, webbing, or alignment notch or hole).

Default Value: GAP/NOTCH

Selections: GAP/NOTCH, MARK, CONTINUOUS

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to scroll through the options.

3.Press SELECT to accept any changes and deselect the parameter.

6/6/08

Z Series®/RZ™ Series User Guide

79695L-002 Rev. A