Zebra Technologies 79695L-002 manual 43

	Operations 43
	Load Media
Roll Media (Continued)	Fanfold Media (Continued)
e. Slide in the media supply guide until	d. Flip up the media supply guide.
it touches the edge of the roll.

e. Slide in the media supply guide until

it touches the edge of the media.

4.Feed the media under the dancer assembly (1), the upper media sensor (2), and the ribbon sensor (3). Slide the media back until it touches the inside back wall of the upper media sensor.

3 2 1

5.Continue with the final instructions for the desired print mode. The print mode must be compatible with the media being used and the printer options installed. See Print Mode Descriptions and Printer Requirements on page 38 for more information.

•Additional Steps for Tear-Off Mode on page 44

•Additional Steps for Peel-Off Mode (with or without Liner Take-Up)on page 45

•Additional Steps for Cutter or Delayed Cut Mode on page 50

•Additional Steps for Rewind Mode on page 51

6/6/08 Z Series®/RZ™ Series User Guide 79695L-002 Rev. A