Zebra Technologies 79695L-002 APL-Donly, ZPL, EPL, APL-I, Set Maximum Label Length, Figure 14 • Label Length

					Configuration	75
				Standard Control Panel Parameters
		Table 12 • Printer Parameters (Page 7 of 26)
	Language/Parameter		Action/Explanation
ZPL, EPL, APL-I			Set Maximum Label Length
			This parameter is used during the media portion of the calibration process.
			Always set maximum label length to a value that is at least 1.0 in.
			(25.4 mm) greater than the actual label length (Figure 14). If the value is set
			to a smaller value than the label length, the printer assumes that continuous
			media is loaded, and the printer cannot calibrate.
			For example, if the label length is 5.0 inches (126 mm) including the
APL-D only			interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
			is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
			Figure 14 • Label Length

}2

3 1

1Label length (including interlabel gap)

2Interlabel gap

3Set maximum label length to approximately this value

Default Value (ZPL, EPL, APL-I): 39.0 inches (988 mm)

Selections (ZPL, EPL, APL-I):Values are adjustable in one-inch (25.4 mm) increments

Default Value (APL-D): 1200i

Range (APL-D):0000i to 9999i (o to 99.99 inches)

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to change the value shown.

3.Press SELECT to accept any changes and deselect the parameter.

6/6/08 Z Series®/RZ™ Series User Guide 79695L-002 Rev. A