Zebra Technologies 79695L-002 ZEBRA, ZEBRA, ZEBRA, ACK_NAK, DSR/DTR, ZPL only, ZPL only, APL-Ionly, Set Protocol, Set Network ID, Send APL-IStatus Response

86Configuration

Standard Control Panel Parameters

Table 12 • Printer Parameters (Page 18 of 26)

Language/Parameter Action/Explanation

APL-I only	Send APL-I Status Response
	Determines if a response is sent after inquiry commands.
	Default Value: ON
	Selections: ON, OFF
	To change the value shown:
	1. Press SELECT to select the parameter.
	2. Press PLUS (+) or MINUS (-)to toggle between the options.
	3. Press SELECT to accept any changes and deselect the parameter.
ZPL only	Set Protocol
	Protocol is a type of error checking system. Depending on the selection, an
	indicator may be sent from the printer to the host computer signifying that
	data has been received. Select the protocol that is requested by the host
	computer. Further details on protocol can be found in the ZPL
	Programming Guide.
	Default Value: NONE
	Selections: NONE, ZEBRA, ACK_NAK
	Note • ZEBRA is the same as ACK_NAK, except that ZEBRA
	response messages are sequenced. If ZEBRA is selected, the printer
	must use DSR/DTR for host handshake protocol.
	To change the value shown:
	1. Press SELECT to select the parameter.
	2. Press PLUS (+) or MINUS (-)to scroll through the options.
	3. Press SELECT to accept any changes and deselect the parameter.
ZPL only	Set Network ID
	This parameter assigns a unique number to the printer when the printer is
	operating in an RS422/485 multi-drop network environment (an external
	RS422/485 adapter is required). This gives the host computer the means to
	address a specific printer. This does not affect TCP/IP or IPX networks.
	Default Value: 000
	Range: 000 to 999

To change the value shown:

1.Press SELECT to select the parameter.

2.Press MINUS (-)to move to the next digit position.

3.Press PLUS (+) to increase the value of the digit.

4.Press SELECT to accept any changes and deselect the parameter.

79695L-002 Rev. A Z Series®/RZ™ Series User Guide 6/6/08