Zebra Technologies 79695L-002 Adjust the Tear-OffPosition, Figure 13 • Tear-OffPosition Adjustment, Table 12 • Printer Parameters (Page 3 of 26)

Configuration 71

Standard Control Panel Parameters

Table 12 • Printer Parameters (Page 3 of 26)

Language/Parameter Action/Explanation

Adjust the Tear-Off Position

This parameter establishes the position of the media over the tear-off/peel-off bar after printing.

See Figure 13. Higher numbers move the media out (the tear line moves closer to the leading edge of the next label), and lower numbers move the media in (the tear line moves closer to the edge of the label just printed).

Figure 13 • Tear-Off Position Adjustment

1

2

1Media direction

2Factory-set tear line location at position 00

Default Value (ZPL, EPL, APL-I): 0

Range (ZPL, EPL, APL-I): -120 to +120

Default Value (APL-D): +128i

Range (APL-D):+00i to +999i (inches), 0m to 2537m (metric)

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) to increase the value. Each press adjusts the tear-off position by four dot rows.

3.Press MINUS (-)to decrease the value. Each press adjusts the tear-off position by four dot rows.

4.Press SELECT to accept any changes and deselect the parameter.

6/6/08 Z Series®/RZ™ Series User Guide 79695L-002 Rev. A