Zebra Technologies P1043301-005 manual Firmware 10/100 Print Server

Introduction

Printer Requirements

25

Firmware — 10/100 Print Server

The S4M printers and all external print servers are available with several versions of print server firmware. PAX4, 105SL, XiIIIPlus printers will use print server firmware version 1.01.x.

To determine the proper firmware version, first determine your hardware version.

To locate your hardware version, perform the following:

1.Which type of printer and print server do you have?

If you have…	Then…
Any printer with an	a.	Look at the side of the print server.
external print server	b. See Figure 1 on page 26. Your version is listed on the
		Compliance label.
	c. Your hardware version number is either blank or V2.
		• If your hardware version is blank, assume this
		means V1 (version 1). You will need firmware
		version 1.01.x.
		• If your hardware version is V2, you will need
		firmware version 2.01.x.
An S4M printer with an	a.	Look at the back plate of the printer.
internal print server	b. See Figure 2 on page 26. Your version is listed on the
		thin Compliance label on the bracket of the wired print
		server.
	c. The version number is shown as blank or V2.
		• If your hardware version is blank, assume this
		means V1 (version 1). You will need firmware
		version 1.01.x.
		• If your hardware version is V2, you will need
		firmware version 2.01.x.
All other printers with an	a.	Your hardware version will be V1.
internal print server	b.	You will need firmware version 1.01.x.

11/21/13 P1043301-005