Zebra Technologies P1043301-005 manual You reach List Network

46

Getting Started

Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers

Printing a Network Configuration Label — Internal

ZebraNet 10/100 Print Server and Wireless Print

Servers

Before you begin, you need to get information from the internal ZebraNet 10/100 Print Server network configuration label.

Table 9 shows the minimum label widths needed to print an internal ZebraNet 10/100 Print Server network configuration label with different DPI printheads.

Table 9 • Label Width

DPI	Inches	MM
600	1.25	31.75
300	2.50	63.50
200	3.69	93.73

To print an internal ZebraNet 10/100 Print Server and wireless print servers network configuration label, complete these steps:

1.Which printer do you have?

If you have a…	Then…
ZM400 and ZM600	a. Turn on (I) the printer and let it complete its power-up
		cycle.
	b. When the POST cycle is complete, press SETUP/EXIT to
		enter the Setup Mode.
	c.	Scroll through the parameters by pressing PLUS (+) until
		you reach LIST NETWORK.
	d. Press SELECT.
	e.	Press PLUS (+) to print a network configuration label
		(Figure 7).
	f.	Press SETUP/EXIT twice to exit the Setup Mode.
	g. Continue to step 2.
G-Series, ZP Series,	a. Turn on (I) the printer and let it complete its power-up
and LP/TLP 2824 Plus		cycle.
	b. Press and hold FEED until you see one flash of the LED.
	c. After the LED flashes, release the button. A network and
		printer configuration label (Figure 9) prints.
	d. Continue to step 2.

P1043301-005 11/21/13