Zebra Technologies P1043301-005 manual Assigning an IP address Without Dhcp from the Control Panel

Getting Started

Assigning an IP Address on any Print Server

Assigning an IP address Without DHCP from the Control Panel

These steps can be used with all printers with a control panel.

To assign an IP address from the control panel (or LCD), complete these steps:

Important • Your ZebraNet 10/100 Print Server must have firmware 1.xx.x and higher and your Zebra printer must have firmware x.10 or higher with a control panel.

1.Turn on (I) the printer and wait until the control panel says PRINTER READY.

2.See Wired Network Parameters on the LCD on page 126 or Wireless Network Parameters on the LCD on page 129 for specific print server menu options or your printer’s user guide for specific instructions on the operation of your printer.

3.You may edit any of the following network settings in order to communicate with any print server in your network environment.

Important • To change any of these settings, you need to enter the printer password. The default password is 1234.

•ip resolution (dynamic, permanent) The printer menu item IP RESOLUTION must be set to PERMANENT if attempting to assign the IP address from the control panel.

•default gateway (default setting of 000.000.000.000)

•subnet mask (default setting 255.0.0.0)

•ip address (if initial default setting is 0.0.0.0, after 2 minutes this defaults to

192.168.254.254

•ip protocol (gleaning only, RARP, BOOTP, DHCP, DHCP and BOOTP, all)

61

11/21/13 P1043301-005