Installation

Internal ZebraNet 10/100 Print Server

Internal ZebraNet 10/100 Print Server

To install an internal ZebraNet 10/100 Print Server, see the installation instructions on the Connectivity Solutions CD.

37

Wireless Print Servers

To install a wireless print server, see the installation instructions on the Connectivity Solutions CD.

Install a Radio Card in a Wireless Print Server

Note • This section applies only to the ZebraNet Wireless Print Server and the ZebraNet Wireless Plus Print Server. All other Zebranet wireless print servers have a built-in radio.

Printers that have the wireless option board installed can use any of the wireless radio cards or Compact Flash wireless radio cards listed in Supported Wireless Radio Cards on page 17. This section provides instructions for installing either type of card. Most printers use a clear plastic RF cover over the wireless radio card or compact Flash wireless radio card.

Wireless Radio Card

This section applies to PCMCIA or CardBus wireless radio cards.

Note • Z4Mplus, R4Mplus, and Z6Mplus printers do not support CardBus wireless radio cards.

To install a wireless radio card, complete these steps:

1.Turn off (O) the printer.

2.Remove and discard the metal cover that was shipped in place over the wireless option card slot on the back of the printer.

11/21/13

P1043301-005

Page 35
Image 35
Zebra Technologies P1043301-005 manual Internal ZebraNet 10/100 Print Server, Wireless Print Servers, Wireless Radio Card