Zebra Technologies P1043301-005 manual From the control panel, enter Setup Mode. Refer to

Getting Started

Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers

47

If you have a…	Then…
HC100			Note • The HC100 does not have a network
			configuration label. However, the IP Address, MAC
			Address, and other useful information appear on the
			printer configuration wristband.
	a. Turn on (I) the printer and let it complete its power-up
		cycle.
	b. Press and hold PAUSE/FEED until the green lights turn
		off on the printer status indicator and the orange lights
		blink once.
	c.	Release PAUSE/FEED to print a printer configuration
		wristband (Figure 10).
	d. Continue to step 2.
ZT210, ZT220, ZT230,	Refer to the User Guide for your printer for specific
ZT410, ZT420, and	instructions on how to use the control panel. (See Figure 9 for
ZD500R	a sample ZT210, ZT220, and ZT230 printer configuration
	label.)
Xi4, PAX4, 105SL,	a. Turn on (I) the printer and let it complete its power-up
ZE500, 105SLPlus		cycle.
	b. When the POST cycle is complete, press SETUP/EXIT to
		enter the Setup Mode.
	c.	Scroll through the parameters by pressing NEXT/SAVE
		(	) until you reach LIST NETWORK.
	d. Press PLUS (+) to print a network configuration label
		(Figure 7).
	e.	Press SETUP/EXIT to exit the Setup Mode.
	f.	Press NEXT/SAVE to permanently save your changes.
S4M	a.	From the control panel, enter Setup Mode. (Refer to the
		User Guide for your printer for specific instructions on
		how to use the control panel.)
	b. Scroll to level 3 parameter PRINT OUT NETWORK
		(for a network configuration label) or PRINT OUT
		SETTINGS (for a standard configuration label).
	c.	Press ENTER to confirm printing.
		The selected label prints.
	d. Press MENU to exit the Setup Mode.
	e.	If necessary, press the up or down arrow to select YES.
	f.	Press ENTER to save changes and exit Setup mode.

11/21/13 P1043301-005