Zebra Technologies P1043301-005 manual Active Device Selection, PAX4

58

Getting Started

Determining the Active Print Server

Active Device Selection

Your active print server selection is dependent on the model of printer or print engine that you have.

If your printer is		Then…
a(n)…
•	S4M	Only one print server (wired or wireless) can be installed at a
•	ZT210	time. Thus, the print server installed is the primary print server.
•	ZT220
•	ZT230
•	105SL	You may select which installed device is the primary network
•	XiIIIPlus	device. The printer will try to use the primary network device as
•	R110Xi	the active print server before trying the other installed options.
•	R170Xi	These printers and print engines use X60.16.x or later firmware.
•	Z4Mplus	The default for the printer is to skip the check for a wired print
•	Z6Mplus	server during bootup. This makes the wireless print server the
•	PAX4	primary network device if a wireless print server is installed. To
•	R110PAX4	change this default and allow the wired print server to be the
		primary network device when it is connected, use one of the
		following methods to tell the printer to check for a wired print
		server at bootup time:
		• the WIRED PS CHECK parameter on the control panel
		• the ^NB ZPL command
		Table 14 identifies which device becomes the active print server
		under various conditions.
•	Xi4	These printers support the simultaneous installation of an
•	R110Xi4	internal, external, and a wireless print server. Even though all
•	ZD500R	three print servers may be installed, only one is connected to the
•	ZM400	network and is the active print server.
•	ZM600	Table 15 outlines priorities and identifies which device becomes
•	ZT410	the active print server when multiple print servers are installed.
•	ZT420	You may select whether the wired or wireless print server will be
•	RZ400	the primary connection by using one of the following methods:
•	RZ600	• the PRIMARY NETWORK parameter on the control panel
•	ZE500	• the ^NC ZPL command
•	105SLPlus

P1043301-005 11/21/13