ZyAIR
Figure 70 Remote Management: SNMP
The following table describes the labels in this screen.
Table 54 Remote Management: SNMP
LABEL | DESCRIPTION |
|
|
SNMP Configuration |
|
|
|
Get Community | Enter the Get Community, which is the password for the incoming Get and |
| GetNext requests from the management station. The default is public and allows |
| all requests. |
Set Community | Enter the Set community, which is the password for incoming Set requests from |
| the management station. The default is public and allows all requests. |
Trusted Host | If you enter a trusted host, your ZyAIR will only respond to SNMP messages |
| from this address. A blank (default) field means your ZyAIR will respond to all |
| SNMP messages it receives, regardless of source. |
Trap |
|
|
|
Community | Type the trap community, which is the password sent with each trap to the |
| SNMP manager. The default is public and allows all requests. |
Destination | Type the IP address of the station to send your SNMP traps to. |
|
|
SNMP |
|
|
|
Service Port | You may change the server port number for a service if needed, however you |
| must use the same port number in order to use that service for remote |
| management. |
Chapter 12 Remote Management Screens | 164 |