
ZyAIR
The following table describes the labels in this screen.
Table 19 IP AliasLABEL | DESCRIPTION |
|
|
IP Alias 1,2 | Select the check box to configure another LAN network for the ZyAIR. |
|
|
IP Address | Enter the IP address of your ZyAIR in dotted decimal notation. |
|
|
IP Subnet Mask | Your ZyAIR will automatically calculate the subnet mask based on the IP address |
| that you assign. Unless you are implementing subnetting, use the subnet mask |
| computed by the ZyAIR. |
RIP Direction | RIP (Routing Information Protocol, RFC1058 and RFC 1389) allows a router to |
| exchange routing information with other routers. The RIP Direction field controls |
| the sending and receiving of RIP packets. Select the RIP direction from Both/In |
| Only/Out Only/None. When set to Both or Out Only, the ZyAIR will broadcast |
| its routing table periodically. When set to Both or In Only, it will incorporate the |
| RIP information that it receives; when set to None, it will not send any RIP |
| packets and will ignore any RIP packets received. |
RIP Version | The RIP Version field controls the format and the broadcasting method of the |
| RIP packets that the ZyAIR sends (it recognizes both formats when receiving). |
| |
| probably adequate for most networks, unless you have an unusual network |
| topology. Both |
| difference being that |
| multicasting. Multicasting can reduce the load on |
| generally do not listen to the RIP multicast address and so will not receive the RIP |
| packets. However, if one router uses multicasting, then all routers on your |
| network must use multicasting, also. By default, RIP direction is set to Both and |
| the Version set to |
Apply | Click Apply to save your changes back to the ZyAIR. |
|
|
Reset | Click Reset to begin configuring this screen afresh. |
|
|
77 | Chapter 5 LAN Screens |