ZyAIR
Note: You must press [ENTER] at the bottom of the screen to save the whole set. You must do this again if you make any changes to the set – including deleting a rule. No changes to the set take place until this action is taken
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 - Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global Start/End IPs.
Note: An End IP address must be numerically greater than its corresponding IP Start address
Figure 152 Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
Menu 15.1.1.1 Address Mapping Rule
Type=
Local IP:
Start= 0.0.0.0
End = N/A
Global IP:
Start= 0.0.0.0
End = N/A
Press ENTER to Confirm or ESC to Cancel:
The following table explains the fields in this menu.
Table 104 Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
FIELD | DESCRIPTION |
|
|
Type | Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are |
| the mapping types discussed in the chapter on NAT web configurator screens. Server |
| allows you to specify multiple servers of different types behind NAT to this computer. |
| See section for an example. |
Local IP | Only local IP fields are N/A for server; Global IP fields MUST be set for Server. |
|
|
Start | This is the starting local IP address (ILA). |
|
|
End | This is the ending local IP address (ILA). If the rule is for all local IPs, then put the Start |
| IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for |
| Server types. |
Global IP |
|
|
|
Start | This is the starting inside global IP address (IGA). If you have a dynamic IP, enter |
| 0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if |
| the types are |
Chapter 28 Network Address Translation (NAT) | 300 |