ZyAIR G-2000 Plus User’s Guide

Figure 200 Menu 24.6 Restore Configuration

Menu 24.6 – Restore Configuration

To transfer the firmware and the configuration file, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your router. Then type "root" and SMT password as requested.

3.Type “put backupfilename rom-0” where backupfilename is the name of your backup configuration file on your workstation and rom-spt is the

Remote file name on the router. This restores the configuration to your router.

4. The system reboots automatically after a successful file transfer.

For details on FTP commands, please consult the documentation of your FTP client program. For details on restoring using TFTP (note that you must remain in the menu to back up using TFTP), please see your router manual.

Press ENTER to Exit:

1Launch the FTP client on your computer.

2Enter “open”, followed by a space and the IP address of your ZyAIR.

3Press [ENTER] when prompted for a username.

4Enter your password as requested (the default is “1234”).

5Enter “bin” to set transfer mode to binary.

6Find the “rom” file (on your computer) that you want to restore to your ZyAIR.

7Use “put” to transfer files from the ZyAIR to the computer, for example, “put config.rom rom-0” transfers the configuration file “config.rom” on your computer to the ZyAIR. See earlier in this chapter for more information on filename conventions.

8Enter “quit” to exit the ftp prompt. The ZyAIR will automatically restart after a successful restore process.

34.3.2Restore Using FTP Session Example

Figure 201 Restore Using FTP Session Examplei

ftp> put config.rom rom-0 200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Refer to section 34.2.4 to read about configurations that disallow TFTP and FTP over WAN.

Chapter 34 Firmware and Configuration File Maintenance

356