ZyAIR
The following table describes the fields not already described insee Table 95.
Table 96 Fields in Menu 11.1 (PPPoE Encapsulation Specific)
FIELD | DESCRIPTION |
|
|
Service Name | If you are using PPPoE encapsulation, then type the name of your PPPoE service |
| here. Only valid with PPPoE encapsulation. |
Authen | This field sets the authentication protocol used for outgoing calls. |
| Options for this field are: |
| • CHAP/PAP - Your ZyAIR will accept either CHAP or PAP when requested by |
| this remote node. |
| • CHAP- accept CHAP only. |
| • PAP- accept PAP only. |
|
|
Telco Option |
|
|
|
Allocated Budget | The field sets a ceiling for outgoing call time for this remote node. The default for |
| this field is 0 meaning no budget control. |
Period(hr) | This field is the time period that the budget should be reset. For example, if we are |
| allowed to call this remote node for a maximum of 10 minutes every hour, then the |
| Allocated Budget is (10 minutes) and the Period(hr) is 1 (hour). |
Schedules | You can apply up to four schedule sets here. For more details please refer to the |
| Call Schedule Setup chapter. |
This field specifies if you want to make the connection to this remote node a nailed- | |
Connection | up connection. More details are given earlier in this section. |
Session Options |
|
|
|
Idle Timeout | Type the length of idle time (when there is no traffic from the ZyAIR to the remote |
| node) in seconds that can elapse before the ZyAIR automatically disconnects the |
| PPPoE connection. This option only applies when the ZyAIR initiates the call. |
If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen. Please see the appendix for information on PPTP.
Chapter 25 Remote Node Configuration | 284 |