ZyAIR G-2000 Plus User’s Guide

Figure 139 Menu 11.3 Remote Node Network Layer Options for Ethernet Encapsulation

Menu 11.3 - Remote Node Network Layer Options

IP Address Assignment= Dynamic

Rem IP Addr= N/A

Rem Subnet Mask= N/A

My WAN Addr= N/A

Network Address Translation= SUA Only

Metric= 1

Private= No

RIP Direction= None

Version= N/A

Multicast= None

This menu displays the My WAN Addr field for PPPoE and PPTP encapsulations and Gateway IP Addr field for Ethernet encapsulation. The following table describes the fields in this menu.

Table 98 Remote Node Network Layer Options

FIELD

DESCRIPTION

 

 

IP Address

If your ISP did not assign you an explicit IP address, press [SPACE BAR] and then

Assignment

[ENTER] to select Dynamic; otherwise select Static and enter the IP address &

 

subnet mask in the following fields.

(Rem) IP

If you have a static IP Assignment, enter the IP address assigned to you by your ISP.

Address

 

(Rem) IP

If you have a static IP Assignment, enter the subnet mask assigned to you.

Subnet Mask

 

Gateway IP

This field is applicable to Ethernet encapsulation only. Enter the gateway IP address

Addr

assigned to you if you are using a static IP address.

My WAN Addr

This field is applicable to PPPoE and PPTP encapsulations only. Some

 

implementations, especially the UNIX derivatives, require the WAN link to have a

 

separate IP network number from the LAN and each end must have a unique

 

address within the WAN network number. If this is the case, enter the IP address

 

assigned to the WAN port of your ZyAIR.

 

Note that this is the address assigned to your local ZyAIR, not the remote router.

 

 

Network

Network Address Translation (NAT) allows the translation of an Internet protocol

Address

address used within one network (for example a private IP address used in a local

Translation

network) to a different IP address known within another network (for example a public

 

IP address used on the Internet).

 

Choose None to disable NAT.

 

Choose SUA Only if you have a single public IP address. SUA (Single User Account)

 

is a subset of NAT that supports two types of mapping: Many-to-Oneand Server.

 

Choose Full Feature if you have multiple public IP addresses. Full Feature mapping

 

types include: One-to-One,Many-to-One (SUA/PAT), Many-to-Many Overload,

 

Many- One-to-Oneand Server. When you select Full Feature you must configure at

 

least one address mapping set!

 

See the NAT chapter for a full discussion on this feature.

 

 

Metric

Enter a number from 1 to 15 to set this route’s priority among the ZyAIR’s routes (see

 

the Metric section in the WAN and Dial Backup Setup chapter) The smaller the

 

number, the higher priority the route has.

Chapter 25 Remote Node Configuration

286