ZyAIR G-2000 Plus User’s Guide

5Use the TFTP client (see the example below) to transfer files between the ZyAIR and the computer. The file name for the firmware is “ras” and the configuration file is “rom-0” (rom-zero, not capital o).

Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP transfer. For details on TFTP commands (see following example), please consult the documentation of your TFTP client program. For UNIX, use “get” to transfer from the ZyAIR to the computer, “put” the other way around, and “binary” to set binary transfer mode.

34.4.5 Example: TFTP Command

The following is an example TFTP command:

TFTP [-i] host put firmware.bin ras

where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the ZyAIR’s IP address, “put” transfers the file source on the computer (firmware.bin

–name of the firmware on the computer) to the file destination on the remote host (ras - name of the firmware on the ZyAIR).

Commands that you may see in third party TFTP clients are listed earlier in this chapter.

Chapter 34 Firmware and Configuration File Maintenance

360