ZyAIR G-2000 Plus User’s Guide

CH A P T E R 20

Introducing the SMT

This chapter explains how to access and navigate the System Management Terminal and gives an overview of its menus.

20.1 SMT Introduction

The ZyAIR’s SMT (System Management Terminal) is a menu-driven interface that you can access from a terminal emulator through the console port or over a telnet connection. This chapter shows you how to access the SMT (System Management Terminal) menus, how to navigate the SMT and how to configure SMT menus.

20.2 Connect to your ZyAIR Using Telnet

The following procedure details how to telnet into your ZyAIR.

1In Windows, click Start (usually in the bottom left corner), Run and then type “telnet 192.168.1.1” (the default IP address) and click OK.

2For your first login, enter the default password “1234”. As you type the password, the screen displays an asterisk “*” for each character you type.

Figure 115 Login Screen

Password : xxxx

3After entering the password you will see the main menu.

Please note that if there is no activity for longer than five minutes (default timeout period) after you log in, your ZyAIR will automatically log you out. You will then have to telnet into the ZyAIR again. You can use the web configurator or the CI commands to change the inactivity time out period.

20.2.1 Entering Password

The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.

For your first login, enter the default password “1234”. As you type the password, the screen displays an asterisk “*” for each character you type.

Chapter 20 Introducing the SMT

252