ZyAIR G-2000 Plus User’s Guide

2.3 Resetting the ZyAIR

If you forget your password or cannot access the web configurator, you will need to reload the factory-default configuration file or use the RESET button on the side panel of the ZyAIR. Uploading this configuration file replaces the current configuration file with the factory- default configuration file. This means that you will lose all configurations that you had previously and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset to 1234, also.

2.3.1 .Procedure To Use The Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.

1Press the RESET button for ten seconds or until the SYS LED, LINK LED or BRI/RPT LED turns red, and then release it. If the SYS LED begins to blink, the defaults have been restored and the ZyAIR restarts. Otherwise, go to step 2.

2Turn the ZyAIR off.

3While pressing the RESET button, turn the ZyAIR on.

4Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly after about 20 seconds. This indicates that the defaults have been restored and the ZyAIR is now restarting.

5Release the RESET button and wait for the ZyAIR to finish restarting.

2.3.2Method of Restoring Factory-Defaults Via Web Configurator

Use the web configurator to restore defaults (refer to the Maintenance chapter).

2.4 Navigating the ZyAIR Web Configurator

The following summarizes how to navigate the web configurator from the MAIN MENU screen.

Note: Follow the instructions you see in the MAIN MENU

screen or click the icon (located in the top right corner of most screens) to view online help.

The icon does not appear in the MAIN MENU screen.

Chapter 2 Introducing the Web Configurator

46