Remington 100089-05, 76728K, 100089-08 Electric Chain SAW, Unpacking, Chain SAW Names and Terms

FIGURES/FIGURAS/

FIGURES

Continued/Continœa/Suite

Flat File/Escofina plana/Lime plate

Depth Gauge/Medida de

profundidad/Limiteur de profondeur

Depth Gauge Tool/ Calibrador de medida de profundidad/Outil pour limiteur de profondeur

Depth Gauge Slot/ Ranura de medida de profundidad/Fente du limiteur de profondeur

Figure 21 - Depth Gauge Tool On Chain Figura 21 - Calibrador de medida de profundidad en la cadena

Figure 21 - Position de lÕoutil pour limiteur de profondeur sur la cha”ne

Front Corner/Ángulo anterior/Coin avant

.025"

.635 mm

Figure 22 - Round Off Front Corner Of Depth Gauge

Figura 22 - Redondeo del ‡ngulo anterior de la medida de profundidad

Figure 22 - Arrondir le coin avant du limiteur de profondeur

¨

ELECTRIC CHAIN SAW

IMPORTANT: Read and understand this manual before assembling or operating this chain saw. Improper use of saw can cause severe injury. Keep this manual for future reference.

UNPACKING

1.Remove all items from carton.

2.Check all items for any shipping damage. If you Þnd any damage or if any parts are missing, promptly inform dealer where you bought chain saw.

CHAIN SAW NAMES AND TERMS

Bucking Process of cutting a felled tree or log into lengths.

Felling Process of cutting down a tree.

Felling Cut Final cut when felling a tree. Make this cut on opposite side of tree from notching cut. Front Handle Located at front of saw body.

Front Hand Guard Shield between front handle and guide bar. Protects left hand while using saw. Guide Bar Metal bar that extends from saw body. The guide bar supports and guides chain.

Guide Bar Nose Tip or end of guide bar. Kickback Quick backward and upward motion of guide bar. Kickback may occur when tip of guide bar touches an object while chain is moving. The guide bar will kick up and back towards operator. Limbing Process of cutting limb(s) from a felled tree. Low-Kickback Chain Chain that reduces chance of kickback as required by ANSI B175.1.

Normal Cutting Position Stance used while mak- ing bucking and felling cuts.

Notching Cut Notch cut in tree that directs fall of tree. Oiler Control System for oiling guide bar and chain. Power Head Chain saw without chain and guide bar. Also known as saw body.

Pushback (Kickback, Pinch) Rapid pushback of chain saw. Pushback may occur if chain along top of guide bar is pinched, caught, or contacts a foreign object.

Rear Handle Handle located at rear of saw body. Reduced Kickback Guide Bar Guide bar that re- duces chance of kickback.

Continued

108539 15 www.desatech.com